FAQs Home

Will the UTARPit™ stick to every kind of roof?

A: Yes, and it works very well in all kinds of Tellos. To make the tent with the glue having the best results need roof surface is clean without waste of materials, or sheets, or sand. Remember if the roofing materials are released from the ceiling, carp to loosen them.

Can I install the UTARPit™ on a wet roof?

A: No, we recommend that you wait until the roof is the driest possible because the glue will not have all its effectiveness, if installed above water. If installed on the roof wet glue will have no problem and will have the same effect but it may take some time up to 24 hours to do.

Can the UTARPit™ be used more than once?

A: No, UTARPit™ can not be used more than once, as if it could easily take off the glue and would not be doing their trabaajo well. The purpose of this glue is to create a tight seal to protect your roof leaks and to keep the tent put even during strong winds.

How can a roofer or insurance appraiser inspect the damage under the UTARPit™?

A: We recommend taking pictures of the damaged area before covering with a tent, since often need evidence for the company roofer or insurance. But if you need to look under the tent, then cut an opening in the center or in the form of X where the damaged area and reseal with another carp UTARPit™ (sold separately.)

Where do I store my UTARPit™?

A: UTARPit™ should be stored in a cool dry place, never in a garage to keep heat as high temperatures can adversely affect adhesive performance and usefulness.

How do I remove the UTARPit™ when I am done with it?

A: You can eliminate UTARPit™ stirring with a solvent but we recommend that you use a professional contractor.